There are a formuled for to calculation of steam lose by traps?
@jorgeromano4722
2 жыл бұрын
Sometimes, trap fault occurs because of "trap fouling" during start up, if foul condensate is allowed to pass by the trap. Foul condensate of start up must be discarded to drains. Thank you for the video
@GregLiguori
5 жыл бұрын
What is the device he is using to check trap.
@mohamedfarishj5287
2 ай бұрын
What is condensate can anyone plz explain
@cachnhiethongtam
5 жыл бұрын
Professional steam pipe insulation designer
@thehvachacker
5 жыл бұрын
Is a boiler with steam coils for forced air, radiators, condensate pump, putting out around 800 MBTU Cutting out at 4 PSI and Cutting in at .5 PSI pressures set way to high?
@pt.miuraindonesia5816
3 жыл бұрын
Great video! so many information about boiler. Miura is boiler too, if you please give me feedback. be awaited. keep spirit
@muthukumararunachalam6344
5 жыл бұрын
Nice video ! Thanks for the content. I have a basic question , what are the major factors to be considered in sizing steam condensate line ?
@modernhustle11
5 жыл бұрын
Btus of the txv I believe
@seeutube8860
5 жыл бұрын
Is there any benefit in balsting and painting steam tracing piping (0.5inch NPS) used to heat vessels and exchangers?
@wareboilers
5 жыл бұрын
There will not be. Hopefully that helps. Thanks for watching!
@michaelfelcher5083
6 жыл бұрын
where is his Hard Hat
@wareboilers
6 жыл бұрын
On this site, Hard Hats were not required so that is why he was not wearing one. Our service techs follow the safety procedures of all of the plants that they go on. Thanks for watching!
@AteebDar
3 ай бұрын
@@wareboilers Bro got a reply from the boiler U themselves, what a legend!
Пікірлер: 15