You’re very welcome Brotha Herson! More S13 rebuild videos are coming soon. Enjoy!
@taylor3014
Жыл бұрын
That was really helpful thanks heaps!!! Also quite funny near the start reminded me of myself in the garage.
@masterofnone1740
Жыл бұрын
Thanks Taylor! I’m glad this video helped.
@ag.3153
Жыл бұрын
Informative video. Good job! Thank you!
@masterofnone1740
Жыл бұрын
Thanks!
@jordans4348
Жыл бұрын
This video is gold.. Thank you Sir!
@masterofnone1740
Жыл бұрын
Glad it was helpful!
@MisterLiBRiUMz
23 күн бұрын
Hey man, at 29:13 there's an orifice on the rack on the left side (the small little hole). Do you know what that is? I refreshed mine and I have fluid coming out of that hole it seems and it's collecting in my boot. That's how it's getting through
@Papajin68
24 күн бұрын
I have to confess I kinda laughed when you shot the ATF across the room... Question for you... how'd you manage to torque the end cap to 50 ft/lbs? Did you end up throwing it in a vice or something? I'm trying to figure out how to manage it on the bench, but I'm not sure how to get the leverage I need without screwing up a machined surface or bending something.
@jdub6909
2 жыл бұрын
Nice job!
@masterofnone1740
2 жыл бұрын
Thank you, J DUB! I’ll be publishing more S13 part rebuilds. Hopefully, these videos help out the S Chassis community.
@felipefalcon4811
Жыл бұрын
you saw 240 tony do it first hahahah same procedure! lovely done!!
@masterofnone1740
Жыл бұрын
Yes, it is meant to help others. This video has additional information that was not covered in other videos similar to this one. I hope you found it useful.
@That1s14guy
Ай бұрын
hou howzit🤙
@MasonTan27
2 жыл бұрын
Thank you! What is the neutral gear in step 1?
@masterofnone1740
2 жыл бұрын
Hi Mason. After installing the gear housing, and measure “rack stroke” on both sides of the shaft to be even. Both sides should measure 68.5mm - measuring from the end of the rack to the end of the part where the tie rod end connect.
@Nolz10
Жыл бұрын
Great video what are the Metal rings used for that come in the kit?
@masterofnone1740
Жыл бұрын
Thanks, Nolz10. The metal rings are the clamps for the steering rack boots.
@jakel7513
7 ай бұрын
Did you just hammer out the inner washer that contacts the the inner seal?
@ag.3153
6 ай бұрын
No, I utilized a homemade L-shaped puller. Once I removed the inner seal with the puller, the washer (center bushing) easily slides out due to gravity. Ensure not to scratch the inner surface of the rack when extracting the seal.
Пікірлер: 25