〜FreeCad を使ってクッキーカッターを作る一番簡単な方法。〜
Convertio(ネット上のフリーソフト)でSVG変換後、FreeCadに取り込んだ線が2重になっている事を利用したシンプルな方法です。
刃の薄さに拘らなければ十分使えると思います。
※線が2重になるかどうかは環境が違うとならない可能性もありますが、もし状況が同じであれば物凄く簡単な操作でカッターが作れますので試してみてください。
※私の場合、線が薄かったり細すぎると2重にはなりませんでした。
※詳しいFreeCadでクッキーカッターを作る方法は別動画で紹介しています。
~The easiest way to make cookie cutters with FreeCad. ~.
This is a simple method that takes advantage of the fact that the lines imported into FreeCad after SVG conversion by Convertio (free software on the net) are double layered.
If you are not concerned about the thinness of the blade, I think it can be used well enough.
If you have a different environment, you may not be able to get double lines, but if you can get double lines, you can make a cutter with a very simple operation, so please try it.
In my case, if the line is too thin or too fine, it will not double.
*For detailed instructions on how to make cookie cutters with FreeCad, please refer to another video.
#freecadtutorial #cookiecutter #ender3
Негізгі бет Super easy cookie cutter with FreeCad.めちゃくちゃ簡単なFreeCadでのクッキーカッターの作り方
Пікірлер