真空脱泡機の使い方を簡単に動画にしました。
【主な注意事項】
⚫︎シリコンの量は紙コップなどの入れ物に対して少量にしないと溢れる。
⚫︎排気口が低い設定なのでチャンバー(鍋のような入れ物)に直接液体を入れてはいけない。
⚫︎いったん真空計の針が停止したら停止位置にかかわらずホースバルブを閉じ、ポンプをオフにします。真空引きを続けるとチャンバーが破損する場合がある。
⚫︎真空ポンプオイルが真空ホースに逆流して材料を汚す可能性があるので
ホースバルブを閉める前に直接真空ポンプの電源をオフにしてはいけない。
⚫︎無負荷(吸気口が大気圧と直接接続された状態)の状態で3分間以上運転すると故障する可能性がある。
⚫︎亀裂発生を避けるために完全な真空状態で真空チャンバーを24時間以上放置してはいけない。
※取扱説明書から大切な部分のみ書き出したので詳しくは説明書を確認してください。
I made a video that briefly explains how to use the Vacuum Pump.
【Point of caution】
⚫︎The amount of silicone must be a small amount for a container such as a paper cup or it will overflow.
⚫︎Do not put liquid directly into the chamber (pot-like container) because the exhaust port is set low.
⚫︎Once the vacuum gauge needle stops, close the hose valve regardless of the stop position and turn off the pump.Continued vacuuming may damage the chamber.
⚫︎Vacuum pump oil can back up into the vacuum hose and contaminate the material. Do not turn off the vacuum pump directly before closing the hose valve.
⚫︎Operation for more than 3 minutes with no load (intake connected directly to atmospheric pressure) may result in failure.
⚫︎The vacuum chamber should not be left in a complete vacuum for more than 24 hours to avoid crack initiation.
※Only the important parts are written out from the instruction manual, so please check the manual for details.
#vacuumchamber #真空脱泡機#silicone
Негізгі бет 真空脱泡機Vacuum Pumpの使い方【How to use】
Пікірлер