After replacing the motor, my connector to the motor was so corroded that I had to replace it instead of cleaning it. So, instead of replacing the whole harness, I replaced the female plug by splicing the wires and then sealing everything with tape. The replacement plug was from another harness I purchased on eBay for $40. My door is working as good as new now.
6 ай бұрын
nice work!
@sirchrisdelta
Ай бұрын
Did you disconnect the 12V or turned the car off before you unplugged the connections?
Ай бұрын
No, did not
@thulanigoronga3120
5 ай бұрын
How much was this front door drive unit??
5 ай бұрын
aprox 250 Euro for new motor, I dont buy a new one manage to clean contact and it worked now one year...
@sirchrisdelta
Ай бұрын
Its still working, or do you have to replace the motor?
Ай бұрын
Still working :-)
@17NaniLuis
Жыл бұрын
Takk for informativ video! Jeg klarte ikke å se hva du brukte for å forsegle koblingene. Kan du fortelle hva du brukte?
Жыл бұрын
Takk. Går fint med gaffa eller elektrikkertape på kontakten og Tec7 på motorskjøter.
@arildolsson1242
11 ай бұрын
Hvordan fikk du motor forbi vindus skinna, hos meg er det ikke plass, og servicemanual sier "remove window"
11 ай бұрын
god plass hos meg X 2017 her@@arildolsson1242
@mortenrune87
8 ай бұрын
Demonterte du motoren, eller bare lot den tørke å hadde på tec7 rundt skjøtene?
6 ай бұрын
@@mortenrune87 beklager seint svar så ikke ditt innlegg før nå, jeg åpnet ikke motor.
@maxcam7933
2 ай бұрын
2019 Raven her, skal t min ut å se om det bare er kontakten...
Пікірлер: 17