I had the same issue, did exactly what you did. I accidentally pulled the steering column off though. You should've seen my eyes when it slid off! LMAO Alas, I had to realign it and place it back on. Then, I still had the rattle because I tried using the Hyundai EPS coupler that others recommended to me. That method did NOT work for me. Maybe I did it wrong, but I went ahead and ordered the correct part and put it back in.
@hispanicuscorpus
2 ай бұрын
Just got a 2013 off the auction. That is the problem holly shipping shelf
@wazid0122
3 ай бұрын
mine gt86 now start to rattle sounds like the whole dashboard behind the steering wheel falling off smooth road nothing brought the part already just waiting for it to arrive nice to see videos with the same problem an how to solve it thanks
@sappk4908
6 ай бұрын
Thanks! I have the same noise
@asriwaqiuddin351
Ай бұрын
could it be the cause my steering vibrate when i break and sometimes during acceleration between 120 -130kmh? Not significant
@charlesmarinier5255
8 ай бұрын
This seems to happen on all toyota and lexus with electric power steering at around 140000 kilometers.
@airbornerefaet7185
Жыл бұрын
How did you fix ABS and traction control light
@moradsaid2145
9 ай бұрын
Simple I recalibrates the angle sensor
@Jaycutler709
9 ай бұрын
Did you pay a dealership or diy for the ABS lights?
@moradsaid2145
9 ай бұрын
I DIY
@moradsaid2145
9 ай бұрын
No dealership
@Jaycutler709
9 ай бұрын
@@moradsaid2145 simple fix? Didn't have to replace any sensors?
@moradsaid2145
9 ай бұрын
Simply fix don’t need no sensor
@mwilke07
Жыл бұрын
I've had the exact same noise for 2 months now, mine is so bad that it happens even on smooth roads.
@rangelsalinas3923
11 ай бұрын
Hey did you get this sorted and if so what all did you do?
@mwilke07
11 ай бұрын
@rangelsalinas3923 yes, I got it sorted. Took off all of the front panels including the radio panel. I did not have to remove the radio. The two screws holding up the steering column, keep them in until you remove the middle bolt, it was the hardest for me to remove/put back. Use a bottle jack to place under the steering column to raise/lower it. Then you can remove the two bolts holding up the steering column to get back to the bushing area. Then just put everything back in order. I no longer have the rattle and it is great! You will need a 10mm, 12mm, 14mm socket, at least an 18" breaker bar, and a screwdriver. If you have questions let me know. The middle bolt was by far the most difficult.
@angelespiritu4981
Жыл бұрын
How did you realign the steering wheel?
@moradsaid2145
Жыл бұрын
I used masking tape as a alignment guide
@moradsaid2145
Жыл бұрын
Then you will have to recalibrate the steering angle sensor
@Jaycutler709
9 ай бұрын
How did you recalibrate the steering angle sensor? I did this process from another video and my rattles gone. But now my ABS / traction control lights are on
@moradsaid2145
9 ай бұрын
You will have to recalibrate the steering angle sensor
Пікірлер: 21