Hi! I am replacing the ECU computer on 05 hilux, how can i reset the ECU?
@user-mx8hx1ly6x
Жыл бұрын
I bought a worker ECU 89661-0D311 for yaris 2008 from another car, I was put on its own but an ANA does not start synchronization? Does the unknown wines write diagnostics
@ScorpionMultimedia
Жыл бұрын
make sure the part number on the new ecu matches the part number on your old ecu and also make sure it came from a car that has the same transmission
@rshaughn11
3 жыл бұрын
What would a tuned ECU do to a stock Yaris with no mods? Would I see any difference? Is the ECU only necessary because of the throttle body swap?
@ScorpionMultimedia
3 жыл бұрын
To a bone stock Yaris you'll still achieve some gains with a tuned Ecu get some hp, little more torque but wouldn't be that beneficial. I got a tuned Ecu because I've done a ton of mods to mines
@jonayego
3 жыл бұрын
How is the ECU reset after installation?? What needs to be done??
@ScorpionMultimedia
3 жыл бұрын
All you have to do is what I did in the video. Disconnect the negative (black) terminal of your car's battery. Once you've disconnected the source of the backup power (your battery), the ECU will reset itself and in doing so will also turn off your "check engine" light. This for any toyota ecu
@jonayego
3 жыл бұрын
@@ScorpionMultimedia I did that and the car could not start
@ScorpionMultimedia
3 жыл бұрын
Are you doing this on a yaris? Are you replacing your ecu with another probably from a junk yard or used one?
@jonayego
3 жыл бұрын
@@ScorpionMultimedia I am doing it on Toyota Corolla fielder. I was told there is something that has to be done to the ECU for it to run. I thought I would see that here, but I have just seen the installation and not the reset of ECU to run
@ScorpionMultimedia
3 жыл бұрын
In my case I didn't have to do anything I just swap the ecu reconnected the battery and it started, in your case it can be anything like if you didn't disconnect the battery before changing the ecu may have shorted something, got a ecu that for the wrong transmission, got a bad/dead ecu, could be the immobilizer in the ecu, etc... Can try another ecu or try original ecu, check 15A EFI fuse (which supplies power to the ECM),15A AM2 and 30A ST fuse (both of which are involved in the starting process), Brake switch - Check continuity on the switch using a multimeter
Пікірлер: 26