I love learning about wierd things like this. Usually comes in handy and you can look like a genuis
@erikferdman9462
7 ай бұрын
same exact problem here 2010 xb customer had a frontal impact right corner. I had the same symptoms except i noticed on hard left turns it would shift the cam over enough to set the same code so i oped the cover and sure was the same cam ring hangin around.
@derekmauricioalfereziniest977
3 ай бұрын
You're My hero man, thanks You for your video, You saved me, i from México city, this moment i'm your fan!! Thanks You!! 🎉
@yeahok115sure
Жыл бұрын
Need more videos on KZitem...... instagram is shit TikTok is shit KZitem is not shit
@theminion4662
Жыл бұрын
Fantastic work 👍
@greghanlon2235
Жыл бұрын
Good job Rob.
@tanimashins8852
7 ай бұрын
Who is this guy😮
@Rikki-D
6 ай бұрын
Great Video! I have a 2009 Toyota Rav4, 4 Cylinder w/112,872 Miles & Toyota is telling me I have a "worn-out/old," not broken Camshaft & I need a New one. Total Cost: $2,400+. It makes a dragging sound when I first start it up but runs perfectly fine afterwards. No backfiring, rattling, nothing but it is consuming quite a bit of Oil. Also, whatever Toyota did, they did not "Reset" my Engine Lights to come back on so, I won't know what the heck is going on!! Question: If I get it Repaired, how long before my Engine gives out? Is it Worth getting repaired or should I Junk the Car?
@clipper7004
6 ай бұрын
For the oil consumption, you could try 0w30 or 5w30 instead of the original spec 0w20/5w20, until/unless you get some new piston oil rings. Having to switch to a thicker oil once oil consumption becomes a problem is something somewhat commonplace nowadays it seems. As for getting specifically the engine light reset, you could ask any auto parts store that knows how to use their diagnostic tool correctly to clear the codes for you, and also have them hand you a sheet that lists what codes you've got. Only do that if it's free.
@Tech-28
10 ай бұрын
Nice work
@Tonyjs24
Жыл бұрын
Thanks for the great video! Was this part of the camshaft or separate part? And is there a part # for the replacement? Thanks so much!!
@societyofspeed9615
Ай бұрын
I have this issue with a 2007 scion tc, has the same 2.4 l 2azfe engine and i have a p0335, i replaced the crankshaft position sensore but to no avail, still have the code and the car is hard to start. Should i pop the valve cover off and see if the camshafts are causing the same generic code
@lauraerickson5492
7 ай бұрын
I THINK I NEED A TUNE UP😊
@CuarentaZ40
Жыл бұрын
Holy shit.. Could running low on oil cause that little bearing/washer on the cam to break? I gotta check my sensor out first tho
@saudydoc
Жыл бұрын
I have a matrix 2009 2.4 has the dame code. I don't want or can't Open de motor like you did. Do you think it willl should worry about it. Car runs fine just the light is on. Thanks in advance
Пікірлер: 19