A visual aid for removing the Automatic transmission for the Nissan/Infiniti R50 platform. Click chapters or scrub video to get a visual on most steps of removing the transmission.
This example shows a 2002 Automatic, 4x4 model with the "full time 4wd" ATX14a transfer case (the plastic dial on the dash)
Please obtain a factory service manual for your year/model and use that to guide you through the project. Do not use this video as your sole guide to your project as there are some errors and there are many year/trim/model differences not covered in this video.
_________Contents__________
00:00 Introduction
5:17 Jack stand prep
6:23 Seat removal
8:21 Exhaust removal
10:39 Drain transmission
11:08 Drain transfer case
12:09 Rear driveshaft removal
13:57 Front driveshaft removal
17:07 Center console removal
20:16 Shifter removal
22:28 4x4 actuator removal (atx14a)
24:25 Transfer case wire harness removal
26:53 Cross member removal
29:19 Transfer case bolts removal
32:47 Separate transfer case from transmission
39:38 Remove transmission dipstick
40:57 Remove transmission cooler lines
43:08 Remove shifter cable
43:46 Remove transmission wire harness
46:49 Remove starter
58:15 Remove torque converter bolts
1:01:22 Remove cross member
1:02:23 Remove bell housing bolts
1:06:03 Disconnect transmission from engine
1:16:05 Post-removal notes
If you are doing this task to fix a rear main seal leak on the 3.5, make sure you understand that you also have to remove the upper oil pan from the engine (Major task). Haynes/Chilton manuals fail to specify this. Check out the video about this on my channel.
(Sometimes) factory service manuals are available here: www.nicoclub.com/nissan-servi...
3.5 Rear main seal video: • Nissan 3.5 rear main s...
Changing ATX14A to/from TX10 tailshaft housings video: • RE4R01A transmission t...
(Sometimes) factory service manuals are available here: www.nicoclub.com/nissan-servi...
Негізгі бет Автокөліктер мен көлік құралдары Transmission Removal - Visual aid for R50 Pathfinder/Qx4
Пікірлер: 31