Just wanted to let you know this video is still helping folks. Thank you, good sir! Much appreciated.
@marcoshernandezhernandez1964
2 ай бұрын
tengo una moto Triumph Thunderbird 900, me sucedio lo mismo, se me rompio la misma, pieza me tardaron mas 6 meses en la agencia para que llegara la pieza, y ponen tantos peros para arreglarla, saludos desde mexico city, que gran trabajo saludos
@charliedflea
Жыл бұрын
This is fantastic! I gotta replace the spring on my shaft! Thank you!
@miketaylor1278
Жыл бұрын
Great video changed mine no problem after watching video luckily I led mine over suspended from garage roof , only one problem the clutch won't fully disengage ,keeps stalling when I put it in gear tried bleeding etc was ok before can anyone help regards Mike
@dereksanford717
3 ай бұрын
Any ideas on how to get the last 2 screws out that hold in the locking plate? Mine won't budge and are rounding out the heads.
@gregkoe60
Жыл бұрын
Good job done 👍
@vincentvaldeavilla9667
17 күн бұрын
Where is oil dipstick for the triump adventurer 1998
@antoniomanchado2026
Жыл бұрын
My thunderbird mixes oil and coolant, please tell me where the possible failure is, thank you.
@thecolonelscustoms8302
Жыл бұрын
Hi Antonio, It was a customers bike and I no longer have the workshop manual but I would start by looking at the coolant pump seals/gaskets. If you don't have any luck there then its a tedious job of going through every gasket. I would have a look on a Triumph forum site and see if there is a common fault for this type of problem. Kind regards, Dave.
@thecolonelscustoms8302
Жыл бұрын
Just been looking on KZitem and found this video. kzitem.info/news/bejne/k7B3yGl_kJN5h5g Does your bike leak water from the teltale holes in the water pump?
@charliedflea
Жыл бұрын
Are you located close to Tyne and wear?
@davidmustard2583
Жыл бұрын
Yes I live near Houghton-le-Sring, how about you 👍
@charliedflea
Жыл бұрын
@@davidmustard2583 I thought I clocked the accent haha I love in boldon colliery, how much would ya charge for this? My 2001 tbird needs the return spring replacing. Think with this vid I maybe able to get through it.
@davidmustard2583
Жыл бұрын
Hi Charlie, Sorry but I am in the middle of a campervan conversion and can't get in my garage as it's rammed with rubbish. I would be happy to give you any advice to help. Regards, Dave
@charliedflea
Жыл бұрын
Thank you very much anyways! I think I shall give it a stab and may throw a question or two your way of I get stuck! Thanks again!
@Wendy-gg9ri
Жыл бұрын
How much to replace shaft including parts and labour! Thanks
@thecolonelscustoms8302
Жыл бұрын
Hi Wendy, Where are you based and how urgently do you need it done. Regards, Dave
@Wendy-gg9ri
Жыл бұрын
@@thecolonelscustoms8302 hi Mark here on wife's phone,sent reply but must have got lost in cyberspace. Anyway saw a legend for sale with broken gear selector shaft and wanted to know cost of parts and labour to replace ,my friend drilled a broken shaft on a Thunderbird a few years ago and it's still good,but it was broken on the spline whereas the legend is broken an inch inside casing so may not be feasible. I could ship back to you if it's viable. Cheers Mark
Пікірлер: 21