I know everyone knows how to google. But it would be great if you put a link to buy this in the video description.
@Hi-bb5lo
Жыл бұрын
This is a very smart idea
@peaceonearth1971
7 ай бұрын
could it damage the tank wall?
@matt27usmc
Жыл бұрын
On average, how long does it take to clean a tank?
@LearnPlumbing
11 ай бұрын
As a Professional im asking myself if I want to offer this product to my clients... Im definetly not comfortable asking a home owner to remove the tank drain, use the tool and properly reinstall. However if I remove the drain and provide them a full port ball valve so they can easily open the valve and insert the tool then perhaps.
@craigmuehleip9121
11 ай бұрын
A lot of people do replace the factory drain valve with a ball valve. This does make future cleaning with the tank cleaner easier.
@mikeches7992
Жыл бұрын
How do you clean hot water line in the tank?
@WarpedinSpace
Жыл бұрын
I have very thick deposits at the bottom of a flat 50 gallon tank bottom. This tool only scraped a little off the surface but was unable to break off the bulk of the material. Any suggestions?
@bluettr250
6 ай бұрын
Reach in there with a screw driver?
@danolanater
Жыл бұрын
Can't you just drain the tank, attach the tool, then refill the tank so you don't make as much of a mess?
@johndao4660
7 ай бұрын
made in usa good stuff are you sure not china
@watchingyou5003
5 ай бұрын
Seems plausable but looking at its execution I say meh. 🤷🏼♂️
@fw1421
5 ай бұрын
Replace that cheap plastic drain valve with a brass one!!!
@Boodieman72
5 ай бұрын
Doesn't look anywhere near as good as the Sediment Buster.
@TruthSeekerAi
Жыл бұрын
why make it so cheap but so expensive it a rip off great idea but made to cheap this is why its hard to support made in the USA this is more like made in china but sold buy a greedy American. make it stronger then this will be worth it
@craigmuehleip9121
Жыл бұрын
Hi AL, Thank you for your comment. We take quality control very seriously. All of the failed and returned cleaners are send back to us for analysis. We have identified and mitigated all know problems. Right now we are out of stock. In a few weeks new and improved parts will arrive. 1. New plastic mold. 2. Changing plastic to polycarbonate. 3. Getting rid of metal sleeve. 4. Thicker grinding disk. 5. New shaft seal. 6. Improved instructions. If you have had a tool failure please feel free to call Craig at 208 520 5579. I will be happy to replace it.
Пікірлер: 18