Air hammer will knock it off a lot faster, but like others have said, great for detail work.
@CFLDumpsters
3 жыл бұрын
An air chisel would be faster, the needle scaler works but slower and is good for small detail areas.
@davegallucci9327
2 жыл бұрын
I agree, I used a muffler gun . works great!
@Ella.818
2 жыл бұрын
1:02
@scottkucinski4967
2 жыл бұрын
I find it satisfying to watch 🤷♂️
@LewisBowels
3 жыл бұрын
I do hull restoration on large vessels and chipping scale rust off of decks, gunnels, foc'sles and padeyes is so satisfying. From brown and orange to a shiny silver after some nice care.
@patricebpatriceb8471
Жыл бұрын
Very nice
@jimthomas777
2 жыл бұрын
I prefer the old fashioned method , Sand blasting
@hgpo27
2 жыл бұрын
Sand blasting doesnt work great for thick rust scale. Quicker to chip it off and then clean the surface with a blaster
@jimthomas777
2 жыл бұрын
@@hgpo27 , I have a air hammer for thick rust and most gets vibrated off , then a little wire brushing and then sand blasting , then POR-15
@hgpo27
2 жыл бұрын
@@jimthomas777 yeah. I'm prepping my frame for my 67 fury. Lots of old undercoat and scale. Probably won't paint because I've had issues in the past. Usually just coat in fluid film
@purelypiercing
3 жыл бұрын
Air hammer and rubber band works way better and faster ... and 25 bucks at harbor freight ... that needle scaler was painful to watch
Пікірлер: 12