hi there.. what was the cause of this? my B10M has just had the same problem... is there a cause to this?
@mickjohnsgarageservices1955
6 жыл бұрын
I've had them go for no apparent reason, but it could be vibration due to wear in the gear drive or the bearings in the housing.
@ITisIwax
6 жыл бұрын
Mick Johns Garage Services How did the B10 drive after you changed the bolts? has it happened/did it happen again?
@mickjohnsgarageservices1955
6 жыл бұрын
I've done three so far, two were fine but one had debris in the bearings from a previous gear drive break repair where the workshop who did it didn't clean out the bearings and the vibration caused the bolts to keep shaking loose. On that one I had to strip the front timing case, remove the drive assy and replace the bearings. While I had it all off I heli-coiled the mounting bolt threads as they had become worn.
@MrCrabbing
4 жыл бұрын
@@mickjohnsgarageservices1955 Do you loctite the new bolts in too
@mickjohnsgarageservices1955
4 жыл бұрын
@@MrCrabbing no I don't loctite the bolts in case of future problems, I do check them periodically though.
Пікірлер: 7