How would I be able to hook up a trim gauge to this . I have the same unit
@cuesun09
8 жыл бұрын
where did you get the o rings ...part #
@robertjkropp9463
Жыл бұрын
How do you get the cotter locking pin off the knob flat end that you screw inn at bottom
@johnbarnes1362
8 жыл бұрын
MrRaven57 , I watched you videos on the tilt trim take apart 1and back together very good and very helpful ! I have that very same tilt trim on my 76 Lancer. my question is which way do the bearing cages face? Video 1 shows that the bearings cages (the side with the crimps holding the bearings in) facing down towards the piston ( opposite of the electrical box). Video 2 does not really show the direction of the bearing on the bottom, and the bearing that goes on top of the clutch you cant tell which direction it faces. I know your video is 3 years old I hope you can remember thanks John B
@MrRaven57
8 жыл бұрын
I don't think it matters which side is up or down.
@davidzorro6649
6 жыл бұрын
Hi , I have stripped mine down and found the worm drive that turns the main big cog is stripped, cant figure out hove to remove and replace , any suggestions or vids please ?
@MrRaven57
6 жыл бұрын
I never took it out . I would guess it e just pulls out once the large gear is out.
@jerryhoward7679
Жыл бұрын
@@MrRaven57 - No. It appears to have two snap rings in there. How can I get to them?
@radeckiPL
4 жыл бұрын
Hi Im looking for to buy this for my dp280 with wire box, maybe someone want to sell it?
Пікірлер: 11