This video covers building TAP, install and configuration ( in this case an MGN9 linear rail ) of the 3d printer along with a few tips and tricks and my final thoughts. This 3d printer is equipped with an mgn9 rail instead of the mgn12 and canbus as well. But the steps will work no matter your setup. There are also some resonance readings to show the impact this mad may have on acceleration. This was done on my Voron 2.4, but could be done on any 3d printer running Klipper.
Voron TAP Github with STL files: github.com/VoronDesign/Voron-Tap
STL for MGN9 Mount: www.printables.com/model/3713...
My printer.cfg file. Please don't just copy the file into your klipper setup: github.com/Kapman1/TAP-cfg-file
If you wish to use canbus as I did, you can get everything you need at: The EBB36: shareasale.com/r.cfm?b=221109..."
If you prefer, the EBB36 and U2c can be purchased at Amazon. I receive commissions for these purchases that directly contribute to the site's content. The Amazon links are:
EBB36: amzn.to/3HrI3pB
U2C: amzn.to/40K6mG5
Green filament: The filament: amzn.to/3LDNiVG
or: The military green ABS and black ASA filament: www.paramount-3d.com/?ref=o45...
Instagram: / kapmansbasementworkshop
Негізгі бет Ғылым және технология Voron TAP build, install, configuration, tips & tricks, final thoughts.
Пікірлер: 181