John Brownings pistol, lasted many years, until …..? You tube and subscription need
@ryanparrish5361
6 жыл бұрын
some of the critical parts you reference are off frame on your video.
@jamesharber7820
3 жыл бұрын
You men are the greatest. Your attention to detail is the envy of all other custom gun makers.
@keithreinert5835
6 жыл бұрын
Do you machine your 2011 frames for commander length? Or do you use ga slides cut down and make up the difference on that end. I'm very interested in learning how it works.
@alibalhas9333
6 жыл бұрын
what is the power of the magnification you using in this video cheers
@IIrandhandleII
3 жыл бұрын
Bush hah
@mikedee6173
4 жыл бұрын
You guys are awesome!
@BallisticExpansion
8 жыл бұрын
What if that ledge inside the frame where the guide rod head sits is gone or nearly gone...?
@AtlasGunworks
8 жыл бұрын
was it cut too much or warn out
@BallisticExpansion
8 жыл бұрын
Atlas Gunworks I should have clarified. not the ledge/relief cut that sits back inside the frame for the center part of the guide rod. I mean on the upper part of the frame. Right above the two "nubs" on the guide rod head. Also there is very slight peening on the inside edge of the frame there. I'm not sure if it was that when I bought it or I am causing it. My dawson tool-less guide rod seems to sit square in the frame. Maybe the fact I am using a 10lb spring?? I have some dykem on the way. I'm going to try and see what is going on in there.
Пікірлер: 16