Another great video. You and the Heating Geek best on KZitem. Thanks for taking the time to make your videos.
@karpilin
5 жыл бұрын
Thanks! Just followed your instructions (minus gas pipe) and managed to replace a leaking flow manifold on my Worcester Greenstar 24i Junior.
@hamzaparvais3948
2 жыл бұрын
Brilliant video thank u again for knowledgeable info
@d.r.plumbingheating3298
5 жыл бұрын
Loving your work! WD40 tip is what I have just learnt!
@BREN2009
3 жыл бұрын
My boiler was dripping through the ceiling tonight I managed to work out how to get the cover off and then found the manifold part I will get it tomorrow and fit it myself minus touching the gas pipe I tried some expoxy putty from bnq for leaks to put me on but did it hell work i roughened the plastic with sandpaper so it would key to it and left it for 2 hours it was rock hard it and the manifold was dry still leaked water always finds it's way out thanks for your video I will give the clips a spray of wd40 cheers
@jitenkothari5073
2 жыл бұрын
Great video
@paulhughes8724
2 жыл бұрын
Wise move wearing gloves on a Worcester
@charlie12358
5 жыл бұрын
Once you've done this once its actually not a bad job and overly common, I find the hardest part is getting the old fibre washers off theyre always soaked and caked on then break off in tiny pieces for some reason.
@24-7ttplumbingheating4
Жыл бұрын
Good video and not to long some videos are just to long .
@worboyes1
Жыл бұрын
Had one of these today and the whit clip at the top had part of the old manifold cracked inside it. Such a miserable job on my least favourite boiler!!
@justsendmelocation5068
4 жыл бұрын
Although Worcester are notorious for leaking o rings to pin hole leak manifolds Working on these boilers is straightf forward.
@mhpservices1
5 жыл бұрын
Massive thanks to Geoffrey for his efforts !!
@antonybuckley2645
5 жыл бұрын
Great videos, what's the rtn manifold like to do on a Jr
@dzmalekvali1110
5 жыл бұрын
Mr Jeffery, I'm having my green star junior 24i giving very hot water ,tried boiler dial low setting still very hot,,could it be the hot water sonsor failing at high setting ? I need to go back check it again..ordered new h w sonsor on the way. Thanks
@snigie
5 жыл бұрын
Nice easy job once you’ve done a couple, don’t know why people complain about them, they pay my bills 👍🏻 Bypass is the fiddlist bit, wd40 is a nice tip though👍🏻
Пікірлер: 20