Make sure when doing strokes use the full length of the stone so your not abusing the middle part of the stone it will make it last longer.
@DoresoomReviews
8 ай бұрын
Good tip! I like that Worksharp included O-ring stops to set the desired travel too.
@adampetten1009
Жыл бұрын
I'd like to see what a knife sharpener would say on this, I bought the lansky version and I'm pretty sure it said to only sharpen on pull
@DoresoomReviews
Жыл бұрын
Interesting - the Work Sharp instructions definitely say and show sharpening on both stroke directions. I wonder what the reasoning behind the difference is.
@SethMorgan-re3mo
7 ай бұрын
I can’t get my knife holder clamp to rotate. I have to take it out and flip it every time.
@BsBucWiLD
11 ай бұрын
I just saw a amazon review that you did about HORL2 vs this WorkSharp, and you saved me $100 for a much better product. Thanks you so much.
@DoresoomReviews
11 ай бұрын
Glad I could help! I was excited to try the Horl 2 as a kitchen knife sharpener, but was so disappointed it didn't perform better. The WorkSharp is definitely the winner in my book - both price and performance!
@FernbarkFrist
Жыл бұрын
I have a really old Lansky model, and this looks way better.
@rollthers3157
Жыл бұрын
What knife is that?
@DoresoomReviews
Жыл бұрын
The knife is the Benchmade Osborne 940: amzn.to/40cMpYj It's my EDC - lightweight, and the Axis lock is the easiest open/close mechanism I've ever used on a pocketknife. Pricey but worth it!
@rollthers3157
Жыл бұрын
@@DoresoomReviews Thank you.
@dougmurdaugh7733
3 ай бұрын
I cannot get this thing to actually work. Steel dust is left behind and you can feel it smooth out with each grit refinement but low and behold, it can't cut paper.
@DoresoomReviews
3 ай бұрын
Try covering the bevel of your knife with a line of sharpie marker. If you're sharpening at the same angle the knife was originally ground at, the line should disappear quickly. If you're trying to change the grind angle to a shallower one than it came from the factory, you can spend a LONG time removing material without actually sharpening the edge. It will show up as the rear of the line getting ground off, but the edge will still show as untouched.
@dougmurdaugh7733
3 ай бұрын
@@DoresoomReviews I appreciate the tip! I think my lack of patience may be at fault. After refining the angle and taking a few more passes, it is getting there.
Пікірлер: 17