Right on! Just followed your vid.. awesome👍 bravo has a little snap on initial throttle.. had a slight delay before.. Thx
@jasonklonowski6282
10 ай бұрын
Great vid! Very helpful I'm starting a restoration project with my son.
@dirtydogadventures6020
10 ай бұрын
Glad it was helpful!
@ezio8591
2 жыл бұрын
thanks, very helpful, I picked up a 2011 LT trapper recently, this comes in handy for summer maintenance
@dirtydogadventures6020
2 жыл бұрын
Glad it helped
@camden3790
3 жыл бұрын
Informative vid. Hope to see more!
@jasonshellop4840
Жыл бұрын
Should the jack shaft on the brake side move around a lot there doesn't seem the be anything hold jack shaft tight on my 1982 bravo
@matthewabernethy124
Жыл бұрын
Can't find any info on adjusting the secondary, does anyone have a link?
@robk5226
3 жыл бұрын
You clean up those sheeves real nice... What grit paper did u finish it off with?
@dirtydogadventures6020
3 жыл бұрын
I just used red scotch bright pads to clean/rough up the surface
@ezio8591
2 жыл бұрын
Hello again, just a quick question. Have you ever taken the bearing off of the jackshaft after removing the secondary? Any tips for getting if off? I don't got a puller atm and the only way I can see to get it off is by taking off the left side bumper and sliding the entire jackshaft with the bearing out. Thanks in advance!
@dirtydogadventures6020
2 жыл бұрын
When I changed bearings i did the chain case side at the same time and had removed the whole shaft, I remember using some heat!
Пікірлер: 13