Thanks, you just saved me two weeks of wait, and $150.
@robertjohnson957
2 жыл бұрын
Very helpful and thorough. Thank you!
@shepss217
2 жыл бұрын
Good video, nice job
@aportilla007
7 ай бұрын
Ese gallo ;)
@AchikSarih
3 ай бұрын
❤❤❤❤❤❤❤❤❤❤❤
@Chris.E.
2 жыл бұрын
Mine is seized in the same spot. Just trying to replace the cables and the throttle cable is impossible to remove without taking off that bracket. Sucks. I tried with an impact driver and it didn't do anything. I don't want to replace a whole control module just because I can't get off a couple of screws.
@TheCuban.45
2 жыл бұрын
Try to cut the plastic to gain access to it.
@grimereaper6994
2 жыл бұрын
Needed
@donc2334
Жыл бұрын
Hi I need to install one of these. Do you know the size of the cutout? I need to either cut a hole in my fibreglass or build a new structure to house it. Thanks much!
@TheCuban.45
Жыл бұрын
It comes with a cutout gide. Tape it and cut the hole. Good luck with the install.
@joseehernandez4037
Жыл бұрын
Loco gracias se. E que eres cubano yo estoy en por charlotte y tuquiero cambiar esa piesagracias
@bobforman5175
2 жыл бұрын
Did you replace with aftermarket or OEM part. And where from and part #. Thanks
@TheCuban.45
2 жыл бұрын
Got the OEM. Links below www.amazon.com/gp/aw/d/B005C58X16?psc=1&ref=ppx_pop_mob_b_asin_title
@dougplommer9961
2 жыл бұрын
why are you changing it out. Problem with shifting? My 2005 f150 has problems shifting. It doesn't move the full amount to fully engage, grinds in going to fwd. but reverse works good. Any ideas. Thinking of replacing the controller
@TheCuban.45
2 жыл бұрын
Adjust the cable. My unit was having problems keeping the speed.
@dougplommer9961
2 жыл бұрын
@@TheCuban.45 I adjusted where it should be, but i opened up the controller and the shifter linkage isn't in sync with the throttle linkage engine speeds up before fully engages. yamaha 2005 1100 hours, very hard on the gears.
@MrArtemiomr
Ай бұрын
Muy buen video brother. Yo al cambiar un cable. Esa pueza la tuve que sacar a pedazos, ahora no se que hacer. Si ahorrarme un dinero casi la mitad con una aftermatket , o irme con la oem, que tu me recomiendas?
@TheCuban.45
Ай бұрын
Be con la d factoria.
@joseehernandez4037
Жыл бұрын
Yo cambié la palanca pero está un poco dura para desengancharlo sobretodo cuando voy a atracar me da mucho trabajo y no se como ponerla suave
@TheCuban.45
Жыл бұрын
Muy posible que tu problema sea con el cable que va al motor.
Пікірлер: 20