Great job Limoux I have a 1975 rd 350 that I am using K&n filter in stock box. It was suggested that I go up to 140 on main and 27.5 on pilot. Although there was a discrepancy some model years came with 120 main and 25 pilot but my bike came with 105 main and 25 pilot. So by going up to 140 main and 27.5 it was too rich and would not rev past 6 k rpm. I am now using 115 main and the 27.5 pilot going pretty good It will red line now. 3rd position on needle think I may go a little leaner could use little more on low rpm.
@RepairandRideout
11 ай бұрын
Thanks for sharing that info, I may try a few more combinations of jet sizes. I have to look at a separate issue, that may be hampering performance, in the next few days. I'll post that on the channel too
@jamescruz6179
9 ай бұрын
@@RepairandRideoutcan u pls share your final settings with me? I'm having issues with my 250....
@jamescruz6179
9 ай бұрын
@@RepairandRideout what did u end up running after tuning & getting it where it'll rev all the way ....? Pls help me I've had it up to here with tuning this thing.......!?😵💫
@stephengunrunnerhanson3550
10 ай бұрын
The plugs look good and a good mixture we had the rd 200 and done every thing the same but just did not run write at the top end the reed valves we replaced them with carbine fiber ones. And that made a great difference ran better and at high revs pulled great done a plug check and plugs were a very good colour 👍
@RepairandRideout
10 ай бұрын
Hi stephen. I have a set of plastic "racing" reeds but refrained from using them as the instructions said that they have a very short life expectancy
@johnnynewburgh9745
11 ай бұрын
I am also running vape Ignition
@briandarnell5966
10 ай бұрын
Love the bike I had two of them in the 80s . Keep a eye out for oil pump feed they're not good if you don't check them regularly and use a good oil for premix.
@RepairandRideout
10 ай бұрын
Hi Brian thanks for your advice. I'll definitely be checking it once the rebuild is done
@howhistory5877
10 ай бұрын
Any reason why you didn't use the 'windows' in the carb body to balance the carbs? After all, it is what they are for.
@RepairandRideout
10 ай бұрын
Hi thanks for your comment. That's new to me what's the technique?
@howhistory5877
10 ай бұрын
@@RepairandRideout You should see an indent on the slides which match up with the hole when you take the screws/bolts out of the body. How you line the indent up with the hole is up to you IE - Just see the indent as it appears in the hole or see the whole indent. Are you also aware that you can 'stroke' the oil pump by adding or removing the shims on the pump rod stop? There is a minimum set stroke but i always increased it a bit as i run K&N filters.
@RepairandRideout
10 ай бұрын
Great advice, everyday is a school day. Thank you @@howhistory5877
Пікірлер: 13