The oil filter should be the metal mesh you didn't put back, it increases the amou t of oil. The paper one make decreases it......overhead problems soon....
@michaelbeharano6656
2 жыл бұрын
Hey sir could you do a video where you change the chain guide on the swing arm
@miladne1092
Күн бұрын
Sprockets and chain didn't need to be changed. You over tightened the new chain, that's not good
@cassaneelyse7726
5 жыл бұрын
Really awesome video! Just picked up a 225 myself. Curious as to which drive chain you used, though? Worst case I'll go OEM, but ProCycle stocks a DID 428 120L that's much cheaper, but it says it's a non O-ring type, and judging from the manual, the OEM is an O-ring type (says to use specific lubricant for one anyway). Let me know, thanks!
@torquemonster8773
5 жыл бұрын
Thanks! The chain I took off wasn't O-ring or anything, and the chain I put on wasn't either.
@greggalbraith2842
3 жыл бұрын
I'm likely too late to get a reply, but was the sprocket simply a stock replacement (45-teeth)???
@nicholasfilion1123
Жыл бұрын
Does your front sprocket have play to slide in and out on the shaft?
@jasonbrown2684
4 жыл бұрын
Great video!! What jack is that?
@torquemonster8773
4 жыл бұрын
Thanks! Its not branded, its an offshore unit i picked up at the local motorcycle show.
@LastDickOnEarth
2 жыл бұрын
What torque do you set on each clutch plate screw?
@torquemonster8773
2 жыл бұрын
I'll be honest, didn't torque them just went by feel. Not sure what the torque value is supposed to be
@TN_HondaDad
2 жыл бұрын
Don't you just love "Exact Fit" by these aftermarket places......sigh......
Пікірлер: 14