Good job , did you say you put a perforated pipe under the roadway in the stone?
@connormcmahon3724
3 жыл бұрын
Yes, just some 4 inch perforated pipe for land drainage👍🏻
@garethmcguinness9858
3 жыл бұрын
@@connormcmahon3724 ah sound. I was askin ye before about track tightener piston on hitachi fh130.didnt have to split chains , theyre holding ok with grease. Got few new track rollers in conatys. Had few small leaks round engine , got new pipes an o rings. Changed all the fuel lined as were perished an letn air in . She flyin now!! Best machine ever round a farm👍
@ferguson20diesel49
3 жыл бұрын
What do you make of the zaxis. It’s hard on diesel I find compared to Fh Ex 135. I found the zaxis no advance whatsoever from dash 5 series. Have a Ex 120 dash 5 with 33k hrs
@connormcmahon3724
3 жыл бұрын
The Ex120-3 I had before the zaxis was incredibly easy on fuel but only had the single hydraulic pump and the working speed/track and dig wasn’t there in comparison to the Zaxis. I actually looked at the ex120-5 before the zaxis and wanted one but very hard to gets good one. I think the dash 5 was probably the best of them! My Zaxis dash 1 is as close to the ex120-5 as you will get though and yes it is harder on fuel with same engine but a lot faster and more productivity and comfort etc. 33k hours is incredible on a machine, fair play👍🏻👍🏻
@kiansutton2795
3 жыл бұрын
How did ye bend the cutting edge on the grading bucket?
@connormcmahon3724
3 жыл бұрын
Believe it or not I bought it like that and a new cutting edge was installed on the bucket but it's not hardox plate, just standard mild steel so I will have to replace it some day. It can get very annoying when doing certain jobs and doesn't cut very well since it has no pointed edge. Well spotted though, thanks for watching👍
@kiansutton2795
3 жыл бұрын
@@connormcmahon3724 nothing worse than a bent edge or a crooked one that would boil yer piss sometimes
Пікірлер: 15