Did ya see the dragonfly at 5:32 saunter across the screen?
@dis82
Жыл бұрын
Great run, boat looks amazing
@chilly7261
Жыл бұрын
Thank you!
@handembroiderycrafting906
Жыл бұрын
Very nice ♥️♥️♥️♥️♥️🌹🌹🌹🙏
@czkarting
Жыл бұрын
Cool boat! I'm into more "vintage" stuff, but good going boat anyway!👌
@camaroboy383
Жыл бұрын
Gotta love outboard tunnel's..😎.. I always liked the g30 kits, mainly because they looks so much like the old htb hulls.. 👍.. Years ago we modified the heck out of the old thunder tiger outboards and ran those.. piped, high timing, altered buttons, high nitro content engine's... I'm not sure if you are familiar with those engines?.. they have an integrated hinge pin that allowed prop angle both negative and positive as normal.. but here is where the trick came in.. If we took the old octura outboard mounts, those like a k&b mount adjusted prop angle at the transom.. used the octura bracket with the tt hinge pin setup we had double angle adjustments.. What this would allow us to do is add a positive at the pin, and a negative at the transom.. it would cancel each other out in straight lines... But in the corners it would start to negative as steering input increased.. this would allow a full throttle sponson lay down in the corners... They were dang near as fast in the corner as on the straights..😉 Just a trick we used to use to have an edge on the competition..😉
@chilly7261
Жыл бұрын
That's some good stuff. Thank you for sharing it...
@camaroboy383
Жыл бұрын
@@chilly7261 no problem at all.. I don't know if it's something you may be able to implement into your transom mount to help with setting up the turns.. You can gain some free mph if you sand the flats of your sponsons as well if you haven't already.. Did you 3d print the outboard hood?. .it looks good all sealed up man.. also what lower are you running on that setup?
@brucekroberts1937
20 күн бұрын
Can you tell what brand of outboard that is? That's a real nice tunnel. Thanks Bruce
Пікірлер: 9