Thank you for sharing! This helped me save so much time and money!
@immmykidsdad
3 ай бұрын
Great work! Appreciate you making this video
@jivan1348
4 жыл бұрын
Thanks this really helped
@fixitmechanic4674
4 жыл бұрын
Your welcome
@louisfredgagnon
3 жыл бұрын
Thanks. Ordered new but they told me to replace shipping oil for pg46 or sp10. Did you drain the system? That did you do to refill it... I'm about to go in a garage for a pro vacuum, oil and refrigerant refill after installing new comp
@fixitmechanic4674
3 жыл бұрын
The AC compressor came with the right amount oil so I didn't add any additional oil to the system
@200932me
2 жыл бұрын
Very helpful, thanks
@XplorinWithPaul
Ай бұрын
Is it the same on the v6 but just remove the alternator?
@chrisl5205
Жыл бұрын
Take out the alternator and removal is a breeze.
@scientist100
6 ай бұрын
I was going to say this but I'm not sure why the manual says to remove all of this fan assy and shroud. I will try removing just the alternator and see if there is enough clearance, looks like there is but I have not tried. I will be doing this next week.
@imnotofficial1660
5 ай бұрын
@@scientist100how did it go?
@scientist100
5 ай бұрын
@@imnotofficial1660been lazy lol but for the 2008 Honda Accord, the fan against the radiator comes off individually and you have plenty of space. Pretty easy if you ask me. I will remove the compressor today. Last time I just touched the bolts around it to see if they were seized as they tend to do that because they are long and tend to rust in the middle which causes the small bolt to be really hard to remove but you just play it back and forth until you get it out. These bolts could break so just play it first.
@SuperCubbyboy
5 ай бұрын
@@scientist100so how did it go? Or you got lazy once again? 🤣🤣
@scientist100
5 ай бұрын
@@SuperCubbyboy went out great, no need to remove the alternator. In my case I had a bolt at the bottom the one towards the pulley where the frame would not let me fit a socket so I could not get a good grip, tried with a wrench but with it not being six points, I did not risk going full at it so I needed to fit a six point socket, it was seized because I live in the rust belt (Indiana). A span wrench fits fine but only try if you can feel that it will be fine, for rust belt like us, dont go full on it unless you have a six point spanner. Had to undo the upper engine mount (one pass through bolt to raise it just enough to get to that bolt. Once I was able to fit a socket with a ratchet, I was able to get it loose. After that everything else is super spacious to work on. Will need short ratchets to fit them around to remove the lines around the compressor.
@theinvestorjl
3 жыл бұрын
Great vid. Took some notes for future reference.
@ipaintu
2 жыл бұрын
I have 2012 accord , and my clutch is not properly engaging, it only engage on and off and blows cold air for the first 3 minutes, and after that it stops engaging completely and only blows warm air, should I replace the ac clutch only or should I replace the whole ac compressor ?
@Lycurgus224
2 жыл бұрын
More often than not, you just need to replace the clutch. But it takes awhile and can be very frustrating to do.
@Abizzy84
3 ай бұрын
Just add 134a, your probably low
@toddthomas110
4 ай бұрын
Nice video, but next time turn your camera sideways so people can see your work better!!
@Ebklifestyle
2 жыл бұрын
What size socket did yu use under the compressor
@fixitmechanic4674
2 жыл бұрын
I use a 12 mm to pull the four bolts for the AC compressor and a 10mm to pull the compressor lines
@Ebklifestyle
2 жыл бұрын
@@fixitmechanic4674 how was new compressor and where did you get it?
@fixitmechanic4674
2 жыл бұрын
AutoZone. Compressor was good
@Cultureshockcrew
3 жыл бұрын
Is this the same for the v6?
@fixitmechanic4674
3 жыл бұрын
Same concept but I got to remove the alternator because v6 engine has less to space to work with compare to a 4 cylinder that has more room to work.
@Cultureshockcrew
3 жыл бұрын
@@fixitmechanic4674 yeah I see that the compressor is under the alternator on my v6. I have an i4 and a v6 and of course the compressor is out on the v6 so I’ve been driving the slug i4 around I wanna fix the v6 so i can put more miles on jt
@christopherjc54
3 жыл бұрын
@@Cultureshockcrew downshift for lots of fun under 65 on the i4 and moderate fun until 100
@sivagopinath6989
2 жыл бұрын
May i know the cost of new Compressor set?
@fixitmechanic4674
2 жыл бұрын
400 to 500 at AutoZone
@marshallsmith3437
6 ай бұрын
150 to 250 Amazon
@Abizzy84
3 ай бұрын
Rockauto has OEM Denso for $281 plus tax and shipping
@ROBI091054
9 ай бұрын
i video degli mecanici africani in strada sono meglio, perche lo hai fatto!?????
@JoeytheKangarooo
3 ай бұрын
Try getting someone to hold you camera or phone. Couldnt see a dam thing
Пікірлер: 34