Installed 12 in Mayhem Bagger bars on my 2014 street glide special and have had limp mode throttle and code issues. Just sharing my experience and how I may have fixed it.
Good thing i watched this video. i put electrical tape over the connectors and ran the wires through with no issues.
@snkr_god
Жыл бұрын
Bro your video helped me install my apes and so happy I found this… I ran into an issue with the throttle grip sensor coming apart in the bars. I just cut green plug and soldered the wires together no more issue…. Thanks again for the content brother!
@mcgyvercustomaudio
9 ай бұрын
Great good a must watch video very helpful.
@jamessnyder7100
Жыл бұрын
Good video brother. Helped me alot
@snkr_god
Жыл бұрын
Great video bro!
@timjohnson8162
5 ай бұрын
Going threw same right now I didn’t pull real hard on the throttle wires but something screwed up
@timjohnson8162
5 ай бұрын
tore all back apart on mine and the little green plug became unplugged when i tryed to pull it passed the hooks so i put it back together and tape it and put back in and once i got to the hook part of the bars i left it there so didnt have to try to get pass the top and i did have enough length to plug in at the bottom.
@janetnirmaier2086
Жыл бұрын
How do you take wires out of a comector
@native6140
Жыл бұрын
Watch the KST video he shows you how to de-pin the connecters
@T.K7601
Жыл бұрын
Hello could someone please tell me where this plug from the throttle by wire goes its not the one with 6 wires but the one with 2 my check engine lights on but bike runs fine. 14 streetglide
@got2b918
2 ай бұрын
I think you're referring to the heated grips wire. Black and white wires with a small black female connector. It just hangs there if you are not using the option. I learned about it because I didn't know either.
Пікірлер: 11