We finally move on to the second side of this widebody and in this episode we make a start on assembling and test fitting the 3D prints. These parts have been printing off in the background for the past couple months. Unfortunately I ran into some issues with warping and so I have to re-print the rear flare, but that was going to take too long to fit into this episode so it's a slightly shorter one this time.
Also a short announcement that this will be my last video for a little while, most likely a couple of months as I focus more on completing this build than filming and editing. I will still be capturing all of the major steps and these will be covered as soon as videos resume.
Thanks again to Stan for his help with his work on the 3D scans and his advice on 3D printing. He has a website and Instagram where you can check out his work.
www.stanscustomcreations.co.nz/
/ stanscustomcreations
As well as his personal Instagram for cool updates on his Datsun Fairlady Z.
/ stan260z
Enjoy the video.
Please consider supporting me on Patreon. There's a lot of time and cost in making these videos and I would love to be able to do these full time to make even more content for you. There are heaps of special rewards and behind the scenes posts so please check it out.
/ tofuautoworks
If you enjoyed this video also feel free to checkout my Instagram where I post regular updates on all of my builds.
/ tofuautoworks
Music in this video:
Jazz Lofi Type Beat "Tokyo" - MetzMusic
• (no copyright music) J...
Timestamps:
00:00 - Intro
00:17 - Recap
00:34 - Processing the 3D model
02:12 - Preparing the 3D prints
03:26 - 3D printing
04:45 - Cleaning up the printed parts
07:40 - Fixing the warped prints
11:04 - Bonding parts with epoxy
13:45 - Sanding!
15:11 - Front flare test fit
16:47 - Rear flare test fit
19:45 - Problems with the rear flare
20:15 - Fitting side pieces
21:10 - Final fitment
22:07 - Quick announcement
23:26 - Outro
Негізгі бет Автокөліктер мен көлік құралдары 3D Printed Widebody! Sky-gea Build: Part 24
Пікірлер: 312