This is awesome to know. as updated to the latest Matter control and didnt know this feature was in it so now every new filament i buy i can quickly run calibrations before commencing on with projects. Using Enders 3 v2 Also to say i have had big issues with wood filament and knowing this is great. i wish when updates have finished their was a change log that would pop up so one can read what has been implemented.
@crossthreadaeroindustries8554
2 жыл бұрын
Great vid, temp calibration has not been something I have done yet and I hope this improves my already good printing on my Ender 3 V2. Is there a guide to settings for the Ender 3 V2 or do the stock settings for the generic "Creality Ender 3" printer that you can find in MatterControl work fine?
@larsbrubaker8898
2 жыл бұрын
The ender 3 should work great. We also just added an Ender 3 V2 that considers the glass bed. If you already have MC installed it only updates the printer list once a day so you may not see the new printer for a little while.
@FixMyHeatHVAC
Жыл бұрын
Would it be worth it to perform the test again with 1deg increments around that 115deg mark for further refinement? Or is that overkill?
@monsterstorm78
2 жыл бұрын
Is this an free program or u gotta pay
@larsbrubaker8898
2 жыл бұрын
It is absolutely free and open source. There are a few (very limited) set of tools that are part of our 'PRO' offering. Their sales help use continue to offer almost everything for free.
@linearburn8838
2 жыл бұрын
Any way you could add the Arterly Family of printers
@WeTheWaveTV
2 жыл бұрын
Can I change my max temperature with this program??
@larsbrubaker8898
2 жыл бұрын
Yes, its under the Filament settings
@WeTheWaveTV
2 жыл бұрын
@@larsbrubaker8898 really? I been trying to use firmware updates but no luck on utilizing my hi temp hot end
@larsbrubaker8898
2 жыл бұрын
@@WeTheWaveTV Sorry, I did not understand your question. I did not understand you were talking about the firmware limit.
@WeTheWaveTV
2 жыл бұрын
@@larsbrubaker8898 tried but wouldn't connect to my Neptune 2s
@WeTheWaveTV
2 жыл бұрын
@@larsbrubaker8898 I have upgraded my hot end to a Creality Spider to print pc but no luck with Marlin or
Пікірлер: 13