Glad to see you used the hammer six or seven times.
@skyking252
4 жыл бұрын
Leo Latch It’s not fixed if you didn’t smack it with a hammer.
@hama4291
Жыл бұрын
sir regarding replacing the oil , do I need the special air compressor oil or I can use any oil ? like a car oil for example
@skyking252
Жыл бұрын
Most motor oils contain a detergent not suitable for conventional compressors. You should use a designated compressor oil. This particular compressor is “oil-less”.
@robertanon1910
5 жыл бұрын
many similar models use the same rebuild parts.
@skyking252
5 жыл бұрын
Robert, you are correct. This same compressor head is found on a great many different brand “oil less” compressors.
@americanidiot9303
7 жыл бұрын
Greg, I have the same compressor and the bearing came apart but the inside won't come off the spindle. What tool did you use to get the bearing off ? Thanks
@skyking252
7 жыл бұрын
I used a ball joint/tie rod separator fork. It wasn't a very tight fit, just stuck.
@americanidiot9303
7 жыл бұрын
Thanks so much Greg! I forgot to ask you where you got the piston kit and bearing?
@skyking252
7 жыл бұрын
american idiot, the kit came from Sears (parts online), I sourced the bearing thru a local bearing house.
@americanidiot9303
7 жыл бұрын
Thanks Greg, You've been a big help!!!!
@reparacionesfacileconomica
7 жыл бұрын
What model is this compressor???
@skyking252
7 жыл бұрын
Sorry for the delayed response. Model #: 919.155731
@pablobenitez2152
9 жыл бұрын
how to replace the fan on the compressor
@skyking252
9 жыл бұрын
+Pablo Benitez I presume you're referring to the squirrel cage cooling fan. It's as simple as removing the one fastener that secures it. Sorry if my answer is a bit on the simple side, but that's really all there is to it and it's shown in the video.
@johntube2525
3 жыл бұрын
Perhaps this comment will help someone else,. My fan fit on the back side not front. Just be careful when you re-install because the squirrel cage should only fit on securely one way. It has a round hole with two grooves coming off at 180 degrees from each other. The round mounting circle is squared off on one side. The receiving stud looks the same as described above. Be sure to put it on right or the squirrel cage will loosen and smack into something. like the bottom side of the new piston sleeve. I did not pay attention to the exact way it must be fasten back on. Therefore it become loose and smacked into the bottom side of the piston sleeve and pieces went flying. I had to buy another squirrel cage fan. Mine would not build pressure over 40 psi. My compression ring was badly worn. I bought a kit which included two rubber gaskets, new piston sleeve and new compression ring. It was very hard to get the new compression ring, once installed on the piston, pushed into the new sleeve. I cut a round piece of wood to fit over the top of the piston and then used a vice to press the new compression ring mounted on the piston into the new sleeve. A small squirt of WD40 helped. It did go in a little crooked, but was easy to straighten out, one inside the new sleeve. Always install the new compression ring into the sleeve, once on the piston, from the top down. Never try to push it in from the bottom up. Building pressure to 125psi like new now. Hope this helps someone.
Пікірлер: 17