what is the rational of using bob weights on an in plane crank of any number of cylinders, if the weights of the reciprocating/piston weights are identical
@brianheiden6623
9 жыл бұрын
Quality build for sure.
@V-ValveSupercharged
8 жыл бұрын
I also need to balance my V6 as well
@jimmydean9006
6 жыл бұрын
What is the name of that machine the actual tool like in general and that specific model. Is it just called "balancer"?
@natashagoushey9149
7 жыл бұрын
Is your machines belt position considered a variable in measurement? It seems close to one side of the crank. (front side.) Would a belt positioned in the center of crank be more accurate? Or do the machine crank supports eliminate that variable?
@UniqueZed
7 жыл бұрын
It does not matter where the belt is positioned.
@wolfy9005
11 жыл бұрын
Usually emergency stop
@cozzm0AU
12 жыл бұрын
Check the Engine Parts Balancing video, it explains bob weight calculation.
@YouTubeChannel2000
5 жыл бұрын
Please provide the link of the video which describes how to calculate the bob weights.
@fordescort1800
11 жыл бұрын
so how do you calculate how far in the drill goes and how do you calculate how much weight in meterial it will remove?
@UniqueZed
7 жыл бұрын
From experience and checking after drilling then drill and check and so on.
@danielhoffman2299
11 жыл бұрын
Is there a standard formula for calculation the bob-weights ?
@eaglebolek712
3 жыл бұрын
100% rotating weight/mass (big rod end with bearing) +50% reciprocating weight/mass (piston with wrist pin, wrist pin locks, and small rod end)
@1magnit
2 ай бұрын
@@eaglebolek712 Only when it's a 90 degree block. When it's a 60 deg block it's about 44% reciprocating. It's half of the sine of the bank angle.
@1magnit
2 ай бұрын
The bobweights need to be concentric otherwise inaccurate. The extra weights hanging off the ends are added as vectors otherwise but still inaccurate.
@fordescort1800
11 жыл бұрын
what does that BIG red button do on the computor thing? i would love to press that
@jorgemartinez8373
5 жыл бұрын
Thats the faster button
@bobawatsit
Жыл бұрын
Ah, I see it is a V engine, then use bob weights, but you set TDC on No1 throw by EYE ?? then go and set your bob weight with a level F.... Me
@aullalaloba
11 жыл бұрын
very good but bored
@richardture4261
6 жыл бұрын
Kill the background noise or put a mike on....can't hear what your saying at times....besides the background noise is annoying.
Пікірлер: 21