I have a question does the ls s80 transmission rebuild kit bk390ws fit my 98 Integra gsr s80 transmission ??
@ufartface
3 жыл бұрын
is there a way to know if its good before you install it?
@speedyme200
3 жыл бұрын
I can vouch for that... a guy on Fb was selling an LS transmission for 300$ I asked him face to face is there any trouble with the transmission and he told me no it works fine.. put it in my car with a b20b swap and have 3rd and 5th pop out with a bad input shaft bearing.
@cerobsan
6 жыл бұрын
Do you also fix refrigerator? I see some bottles of refrigerant fluid on the background 13:29
@Cervan
6 жыл бұрын
Celio Santana yes I also do hvac
@markgiron860
4 жыл бұрын
Hi, Im trying to rebuild a 2000 honda crv Manual transmission. Can you tell me if i can use other B series internals on that Transmission? Thanks alot!
@Cervan
4 жыл бұрын
Wish I could tell you, unfortunately I've never had the pleasure of working on one of those, I would assume the gears and shafts are similar but I'm not sure. A good person to ask that would be transzex on d-series.org if he's still around
@markgiron860
4 жыл бұрын
Thanks Man
@unclequack5445
2 жыл бұрын
Sir 5th is the smaller gear you called 1st gear 5th gear the lowest gear is the bigger one.
@lospentecostalesdemoorsvil1217
3 жыл бұрын
Amigo can you rebuild my Acura transmition integra gsr 2000 ha much You charge me thank you
@gnarlytek1331
6 жыл бұрын
Dude how much to rebuild my transmission
@Cervan
6 жыл бұрын
gnarly tek what's wrong with it?
@gnarlytek1331
6 жыл бұрын
Cervan when down shift to 1st from 2nd gear it grinds and where the slave meets the case the holes are messed up can't get a bolt to fit
@gnarlytek1331
6 жыл бұрын
I wonna try to do it myself but it looks way to krazy for me
@Cervan
6 жыл бұрын
Yeah downshifting from 2nd to 1st while moving is a common problem that isnt always related to an issue with the transmission, but is sometimes a symptom of another issue (dragging clutch will cause grinding issues, such as with your damaged slave threads).A normal rebuild (no broken gears/teeth just bearings and seals) is around 400-500$ unless you have other parts that need replaced such as synchros or selectors and much you want to replace (All bearings or just the ones that are damaged). I also repair cases, the damaged slave threads are a common issue, weld them solid and then redrill and tap them to the original size.
@gnarlytek1331
6 жыл бұрын
Cervan I don't think its clutch drag but ok I need this work done not sure what's going on in there but I need tranny to pulling good
Пікірлер: 17