You picked up on that pretty quick, I wasn't expecting that.Well done.
@HWrenMaintenanceServicesLTD
11 ай бұрын
Sometimes faults end up being ridiculous things that you would never expect. Thanks for watching and the comment!
@Gubsygaming
Жыл бұрын
This was really educational to watch!
@HWrenMaintenanceServicesLTD
Жыл бұрын
Thanks for watching and the comment!
@seandempsey7351
2 жыл бұрын
Great job . Well done 👍 Great video mate 👍👍👍👍❤️
@HWrenMaintenanceServicesLTD
2 жыл бұрын
Thanks, much appreciated 👍
@sarahholland2600
4 ай бұрын
This was so useful. Thanks.
@HWrenMaintenanceServicesLTD
4 ай бұрын
Glad it has been a help. Thanks for watching and the comment!
@yamawsacornishpasty5525
6 ай бұрын
I have a question. I recently just moved into a flat, now we had a friend put up the light fixtures and yesterday they both just stopped working, we've checked the fuse box, they're all on, but it's affected my use of the kitchen sockets. What might be the problem?
@HWrenMaintenanceServicesLTD
6 ай бұрын
Without seeing it, I cant advise for certain. Have you checked RCD in the fuse board as well as the Mcb? The only thing that springs to mind is that one of the lights may be faulty and tripped the RCD which will protect multiple circuits, hence affecting your sockets. Other than that, the lighting circuits should have no effect on you sockets.
@oniv5240
7 ай бұрын
Cheers lad. What volt stick do you use here?
@HWrenMaintenanceServicesLTD
7 ай бұрын
There's no markings on it that I can see (had it a long time and have worn off), but I'm pretty sure it is C.K. Just googled it, I think its the CK T2272. Thanks for watching and the comment!
@seandempsey7351
2 жыл бұрын
You checked the RCD but not the MCB you should have checked both really,
@HWrenMaintenanceServicesLTD
2 жыл бұрын
Thanks for watching and the comment, however, if you watch this again you will see the MCB is directly next to the RCD. Both were initially visually inspected then both tested later using a multimeter. Regards, Haydn
@donlunn792
Жыл бұрын
@@HWrenMaintenanceServicesLTD Hi Haydn, ha,ha .even though I’m not an Electrician,I saw what you did, Regarding the comment about not checking the MCB. So many people on KZitem jump on things that if they really watch the vid they would see the error of their ways. Instead of this (No one can do it like I do mentality.) Thanks for giving your knowledge for free.
@HWrenMaintenanceServicesLTD
Жыл бұрын
Thanks for watching and the comment!
@odomic
Жыл бұрын
Sound is low
@HWrenMaintenanceServicesLTD
Жыл бұрын
Unfortunately, this was one of my early videos when I didn't have a good microphone.
Пікірлер: 18