Probably not going to get a quick answer on this, but how do I transfer the template info to the actual panel? Do I assume the distance from the edge of the panel is the same as the edge of the level?
@KurtKriese
Ай бұрын
When adding additional blocking - for ADA grab bars, should that blocking be covered with the sill plate gasket material as well?
@robertschaaf7192
Ай бұрын
it will never get wet
@KurtKriese
Ай бұрын
@@robertschaaf7192 My understanding is that the sill plate gasket material is for sound deadening, not an issue of dry/wet. That's why I asked about the other blocking sites, since they are not mentioned in the video.
@toddsmith231
28 күн бұрын
I did. seals and doesn't squeak
@savannab.2554
6 ай бұрын
Is the foam tape mold proof or should it be protected?
@billhamilton7524
Ай бұрын
total waste of time ,,,nowhere do they mention the depth of the mixer valve ,,impossible to set without that info ,,what a joke
@toddsmith231
28 күн бұрын
probably way too late to be relevant. I recently went through mixer install and ran into that issue. Bought a phister, which had very little documentation, my 5th grade grand-daughter could've written better instructions than they did. I ended up taking the valve back and after researching instructions, settled on a Moen. Excellent instructions and appears to be a quality product. It has specs relevant to depth and etc. I suppose the mixing valve manufacturer would be responsible for producing an instruction video with these kinds of q&a. Regards....
Пікірлер: 8