First of all, great video. I'm new to laser engraving, I bought an xtool s1 which I love! What would you recommend to get if I want to engrave a ceramic black plate, I want the image to really show. Any suggestions would be appreciated. Thanks.,
@pascalviaene6067
8 ай бұрын
verry nice and clear review , thank you
@Michelle88-hola
27 күн бұрын
Nice….but was the black sprayed down first and then the white chalk paint?
@justfilming
9 ай бұрын
How easy the spray chalk comes off
@ebpman
9 ай бұрын
Water and just used my hand. Super easy
@user-zy3gn2hz7m
6 ай бұрын
I have d1pro can I create a rectangle of my decanter in the software and get it to engrave in the center?
@kimby333
9 ай бұрын
Would that method work for clear acrylic too?
@jeffcooper2464
9 ай бұрын
Hi, I have the 20W S1 & wondered if the settings of power 60% & speed 100 mm/s would be the same for engraving on the 20W machine?
@billababe5157
8 ай бұрын
@ebpman I had the same question. Could you advise?
@RyanNiemer
8 ай бұрын
I just ordered a 20W. I would just plan on sacrificing a board to set up the speed / power test that is a feature of the design space
@sargentspursuit8738
4 ай бұрын
For my S1 at 20w using the Rustoleaum Cold Galv Compound from home depot, I ran at 25%power and 100mm/s with 3 passes. The 1st pass burns the material but leaves it black. 2nd and 3rd pass clean away the burnt material and when you wipe it clean you get the perfect frosted glass look!
@keylitho
5 ай бұрын
Glass is the worst cutting board material you could have.. 🤦♂️ But I like how the engraving worked.. came out nice.👍
@drkline69
Ай бұрын
CerMark spray will give you black on glass.
@Michelle88-hola
27 күн бұрын
Was the black sprayed down first and then the white chalk spray?
@drkline69
18 күн бұрын
@@Michelle88-hola if you use Cermark then you don't use chalk spray or anything else.
Пікірлер: 15