Where to get gt series 2.2kw command register address, Status register address, spindle register address? Etec stuff like that not on manual
@StanBlaszczyk
3 жыл бұрын
Is there a plug-in available to allow running of gt vfd with Mach 3 rs485 control? I have the vfd configured but cannot get Mach 3 plug-in from Hy vfd to communicate with gt series vfd. Thank you
@Ratheon1075
3 жыл бұрын
I have the VFD up and running the spindle but it will not accept RS 485 communications. I have the following parameters set. P0.01 - 2, P0.07 - 7, PC.00 - 1, PC.01 - 3, PC.02 - 0. The PC.00 through PC.02 match the com settings from the computer and are the same settings used in my previous HY VFD. I have tested that my communications from the computer still work with that VFD. Have I missed something or is there a problem with this VFD?
@huanyanginverter6516
3 жыл бұрын
PC0.01 PC0.02 These two parameters must be determined to be the same. 485 communication requires feedback. The 485 format of GT series is different from the 485 format of HY series. . The product data format of the HY series cannot be used on the GT series
@LIPSITkimaaRAND
4 жыл бұрын
I bought HY VFD, i had so many problem setting it up, mine was not factory programmed, also can u make it Clear POWER IN is well described
@huanyanginverter6516
4 жыл бұрын
kzitem.info/news/bejne/maOYsqtpsqafeaQ
@alld4120
4 жыл бұрын
Hi! I have an inverter HUAN YANG GT series and NC Studio please tell me how i need to connect all these things
@THAIDIY
4 жыл бұрын
Can we set the vfd to automatic running when input the power source?. (Sorry for my english)
@huanyanginverter6516
4 жыл бұрын
of course can,,
@THAIDIY
4 жыл бұрын
@@huanyanginverter6516 Can you suggest me about that.
@huanyanginverter6516
4 жыл бұрын
@@THAIDIY Which model of product did you purchase?
Hello, im trying to get working vfd gt series with usb mach3 controller and mach3 software but I cant get working it. I read and followed thé manual but nothing, please help whats wrong, I connected +10v with 10v, AI1 with avi, s1 with output 1, and gnd with dcm and acm respectivly. I put p0. 01=1 p0.07=1 p0. 13=0 p5.01=1. Spindle works perfect from keypad, please your help, thank you
@huanyanginverter6516
3 жыл бұрын
Reference video kzitem.info/news/bejne/rHqVtKachWmLjag
@thomasjampedersen3111
5 жыл бұрын
Try this software for your VFD: open source github.com/copenhagenatomics/SpindleTalker2
@carneeki
5 жыл бұрын
Oh man, I didn't know Copenhagen Atomics had a GitHub! This just makes them even cooler :)
Пікірлер: 22