Hello. I have one of your vfd's. Do you have a link to the manuals? I am trying to get it controlled in mach3 and without full manual it is difficult. Thank you.
@elshantagiyev
3 жыл бұрын
Hello. I am very pleased with the purchase of 2.2 kW. But i need your help. Tell me how to connect the inverter to NVEM v2 NOVUSUN
@zak7990
6 жыл бұрын
i have 7.5kw VFD that is for this motor to run air compressor and is still little bit struggling to run that compressor start is good but when it comes towards where the compressor should be stoped by pressure switch it slows and want to stop by it self what can be done to fix this so it can run properly. thanx.
@huanyanginverter6516
6 жыл бұрын
I can’t understand your meaning, Can you send me a video?My email: service @hy-electrical.com
@Johnchew7
3 жыл бұрын
@@huanyanginverter6516 which is your email? i cant sent email to you
@automateanything
6 жыл бұрын
What is correct wiring of switch 1 for 485 operations
@huanyanginverter6516
6 жыл бұрын
There are 485+ and 485- terminals on the motherboard.
@Johnchew7
3 жыл бұрын
need help for setup mach3 control spindles speed with GT 7R5g-4
@Johnchew7
3 жыл бұрын
my email : hewgant86@gmail.com
@Smokeslingerowner
6 жыл бұрын
I bought one of your 2.2 VFD. The potentiometer will not adjust rpm on my spindle .
@huanyanginverter6516
6 жыл бұрын
P0.07 = 2,Wiring AI2 GND
@aticafloorable
4 жыл бұрын
sir I have a model GT-4ROG-2 I need the parameters for remote on, off and speed control. thanks
@huanyanginverter6516
4 жыл бұрын
kzitem.info/news/bejne/rHqVtKachWmLjag
@zak7990
6 жыл бұрын
Hi, need some help programing VFD HY01D523B to run air compressor motor 3phase 380v 4kw 2900rpm the manual is bit confusing to understand, in Pn12 Motor rating frequency 010.00Hz-and 400.00Hz Default Value Default(3) Default(6) 400Hz-50Hz if i put it to 50Hz its spinning very slow and if i put it to 400Hz it spins very fast motor needs to spin at 2900rpm how can i fix this? thanx.
@huanyanginverter6516
6 жыл бұрын
HY01D523B is 1.5KW 220V VFD. Your motor is 4.0KW 380V. It is wrong to use a 220V VFD to drive a 380V motor. You must use ≥4.0KW 380V VFD to run your motor.
@huanyanginverter6516
6 жыл бұрын
kzitem.info/news/bejne/mK2ZqWyam2ZyoJw Настраиваем частотный преобразователь Huanyang GT серии для работы со шпинделем 2,2 кВт. А так же подключаем данный частотник к Mach3 через аналоговый выход. В конце пример 3D обработки на моем станке.
Пікірлер: 19