I don't know what it is about vintage outboards that sends good vibes within us; could it be that we want to return of how things were? Love it gracias
@JeffMorris-dq3up
Ай бұрын
I have one that I'm trying to get going again. I used it when I was a kid, then one of my cousins had it. I found it in a shed where it sat for 20 years with fuel in the tank. Fingers crossed I can get it going again.
@arnarne
6 жыл бұрын
Wonderful little motor. It looks just lovely being out there in that boat and with that little Johnson!
@MrJuliesguy
8 жыл бұрын
Sweet video, I just picked one of these up tonight, it was "locked up" so I sprayed some PB Blaster down the cylinders and broke it free, it started on carb clean (I know, I shouldn't do that) so now I will properly rebuild the carb and do a new impeller and hopefully it will run as nice as yours...thanks for sharing
@jaredshelton4718
4 жыл бұрын
Beautiful boat
@jaml250
10 жыл бұрын
Kiitos, kiitos! Omaan silmään nuo Evinrudetkin on yhtä hienoja koneita. Jos sattuu sopivasti tarjolle, niin voisi hankkia sellaisen sillä weedless-perällä. Joo, kuoria lukuunottamatta täysin samoja koneitahan nämä ovat.
@gioscervelo
3 жыл бұрын
Nice boat. Any info on the boat.
@lbbradley55
4 жыл бұрын
My father found the one I have like this in a Pawn shop for $35 for my Canoe. Mine is a 1948 we believe. It has different side covers. My father passed but my 40 yr old son remember well being a small kid in front of the Canoe with our 3 HP pushing us to the swimming hole
@iansrving
10 жыл бұрын
I replaced the coils and spark plugs. Condensers are good. I bought some feeler gauges recently and the points are good. Motor has a nice strong spark. Cleaned magnetos on the flywheel. Carburetor was cleaned recently. Carburetor seals are good except for those packing washers. New head gasket and head replaced due to loss of compression from a bad head gasket and cracked head. New Head bolts. Water pump impeller was good. I cleaned the inside of the exhaust chamber and motor leg.
@iansrving
10 жыл бұрын
Everything seems good to go with the exception of the carburetor. Would you happen to have any suggestions on where to get a carb kit? What worked best in your eyes?
@iansrving
10 жыл бұрын
I will post a video soon if I ever find the right program. If you don't mind me asking, what program do you use?
@jukusamonen4908
9 жыл бұрын
Makea kone. Mulla on vastaava 1965. Tuo tyhjäkäyntisi on loistava, siinä on se todellinen haaste. Kannattaa tosiaan huoltaa vuosittain niin pysyy kunnossa. Itse olen vaihtanut puolat+sytkäosat ja kaasarin tiivisteet (+useita kannentiivisteitä), mutta ikävä kyllä tuo jäähdytys aina välillä temppuilee kun akselin kiila tuppaa syömään vesipumpun kotelon yläosastaan rikki ja veden pumppaus lakkaa koska kiila ei osu enää vesipumpun rattaaseen. Olen ratkaissut ongelman sokalla pystyakselin yläosassa, joka estää akselin liiallisen nousun ylöspäin. Olen useasti ollut myymässä konetta mutta nyt aion pitää sen (25 vuotta takana) kun sain sen taas kuntoon.
@jaml250
10 жыл бұрын
Maybe some online shop or ebay would be good places to get a kit. Post some video of your motor!
@noway57
7 жыл бұрын
thats a really nice little boat. that one doesnt seem to have as much punch as my 3hp 85 2cylinder 2 stroke.
@jaml250
10 жыл бұрын
My motor has new coils now. Old coils were cracked and motor didn't ran well. That is common problem with older OMC's. I also installed a carburetor kit on mine. The carburetor has new seals and a float assembled. Points are set to 0.02". You should have those packing washers in the low speed needle seat. Your mixture is bad now and motor won't idle right. Maybe the carburetor needs new seals and good cleaning. After that check the ignition system.
@iansrving
10 жыл бұрын
Hi, my name is Ian. I have a 1966 JW21E (very similar to this) that I am doing a full restoration on. I was wondering how you got yours running so well? That idle was amazing, and the full throttle was too! The problem with mine is that when I got mine it ran like that. But when the rubber packing washers went dry rot; they jammed up the low speed screw, and well I took them out and didn't bother replacing them. It won't idle worth crap and only runs at 3/4 throttle. Please help me. Thanks.
@dreamdiction
3 жыл бұрын
I'm surprise how noisy this engine sounds. is the exhaust under water as it should be?
@joeoglesby3975
2 жыл бұрын
Like to boat too. What kind is it?
@andypontinen
10 жыл бұрын
Oon myös kunnostanut kaverille vm-59 3 hp Evari Silver Jubileen, ja siitä on mun KZitem sivuillani videokin.
@ClassicNewman
3 жыл бұрын
What ratio do you mix your gas? I just got one of these relics.
@jaml250
3 жыл бұрын
I mix my gas in litres: 5 liters of gas plus 0.15 liters of oil. So the mixture has about 3 % oil into.
@andypontinen
10 жыл бұрын
Mulla on kaikki koneen alkuperäiset paperit tallella (esitteet, käyttöohjekirjat) sekä alkuperäinen huoltopukki. Kone oli jo joutua pariin otteeseen romustajalle mitättömistä syistä johtuen, mutta henkkoht pelastin sen enkä aio ikinä luopua. Kone oli yhteysveneen moottorina Kyyvedellä parikymmentä vuotta. On kyllä komea tuo sun Johnsoni. Mun mielestä Johnsonin 3 hp on aina ollut hienomman näköinen kuin Evari, vaikka tekniikka sinällään samankaltainen.
@danielsvensson356
4 жыл бұрын
What oilmix do you use?
@sethgabbard7705
4 жыл бұрын
Daniel Svensson 16:1
@dreamdiction
3 жыл бұрын
@@brianchisnell1548 You have ball bearings instead of roller bearings.
@brianchisnell1548
3 жыл бұрын
Single carb adjustment screw must be their cheapest model. My 1967 has one adjustment (low speed) knob. $189.00 when new.
@JohnSmith-yn8pl
6 жыл бұрын
Do these motors have a water pump? I have a Brooklure 3 hp & cannot find a water pump on it. If anyone knows...please reply here. Thanks
@arnarne
6 жыл бұрын
Yes, they do have water pumps. It is a rubber kind of star wheel that propels the water up to the cylinders and it sits in the housing just near the propeller. I hope you understand. My first language is not English...
@pierresmith811
5 жыл бұрын
yes evry motors have a water pump
@brianchisnell1548
3 жыл бұрын
Get a manual
@ThePretzelHead
3 жыл бұрын
The sound of my father
@andypontinen
10 жыл бұрын
Terve. Kas kun joku muukin SUOMESSA fiksaa vanhaa OMC:n konetta, tuppaa nää olemaan vaan jenkkien harrastelukohteita. Itselläni Evinrude Lightwin 3 hp vm. - 63 pitkärikinen (kopan yläosa valkoinen,alaosa sininen), on mun jo edesmenneen isäni uutena ostama. Oon kunnostanut nyt sitä 2 vuotta ja alkaa olla teknisesti valmis koekäynnistykseen. Rakensin sytytyspuolen ja kaasuttimen täysin uusiksi, sekä vesipumpun ja alavaihteiston kaikki stefat uusiksi (sekoitti jo vettä ja öljyä).
@linconnuqcqc7602
3 жыл бұрын
Where is the out of water pump ?!
@owenchew8293
Жыл бұрын
Under the water line
@mikesmith1550
2 жыл бұрын
Put a GPS to work so there is some useful info generated besides just a nice boat ride video.
Пікірлер: 36