I've also made pnp machines.. just wonder what kind of feeder selection did you used.. It's placing 1 noozle for led chip and the other 1206 resistor.. Did you use reference tube feeder? That will take alot off string to set up.. Regards
@ederangelo21
7 жыл бұрын
Best Regards, ..EDER - BRAZIL
@404Anymouse
4 жыл бұрын
Why did I watch the entire thing?
@crisizz
6 жыл бұрын
Hello, would you like the structural schematic of the machine?
@friemae
7 жыл бұрын
hey, i am planning my own machine and i very much like the way you solved the feeder issue, this is a really nice design. How did you create the strip feeder holders? Is there anything on the openpnp forum?
@BogdanHEX
7 жыл бұрын
I have a CNC and milled some PVC plastic to hold the strips. I think there are some examples, is simple to do if you have a CNC machine.
@stumpy1495
7 жыл бұрын
I'm curious, what's the smallest component size you get a reliable placement on? Also, do you think a vision system would help?
@BogdanHEX
7 жыл бұрын
So far i didn't had time to test it under 1206, but i think it would do well with 0805 and 0603. That is all i need.
@BogdanHEX
7 жыл бұрын
There is more to add to this machine: automatic feeders, bottom vision camera, automatic nozzle change. Right now it has only top vision camera, but need some adjustments ( camera is too close to pcb, image is blurred )
@stumpy1495
7 жыл бұрын
BogdanHEX That's more than good enough for 99% of what I need. Thanks for the reply. :)
@G36934
6 жыл бұрын
Nice PNP. What toolhead is that?
@zgk_tech8130
4 жыл бұрын
Nice job please must see this and need how to add this.... @
@sharadpthaker6764
7 жыл бұрын
What is the resolution of this pnp machine?
@xpolhecx
5 жыл бұрын
Can you please share design for tape&reel tray/fixed feeders. Is it made out of plexi glass?
@IceTurf
5 жыл бұрын
What sort of placement speed can this thing get up to?
@MilanPotterSmith
7 жыл бұрын
have you released files for this ? where did you get idea. nice board
@orhanfeyzioglu6297
2 жыл бұрын
What is the name of this machine?
@ravdobrzynski
4 жыл бұрын
Prowadnica kablowa do góry nogami.
@andriusjurevicius5806
4 жыл бұрын
What kind of motors do you use?
@cathyxu1284
4 жыл бұрын
Hi, how r u?
@FLYBYMEable
4 жыл бұрын
I see 2 strip feeders but no tray feeder.
@organizatie
6 жыл бұрын
Salut, Laurentiu ma numesc pot intra in legatura cu tine??sunt interesat sa-fi fac si eu o masina de pnp.multumesc
@truongnguyen6259
6 жыл бұрын
Could you please tell me how to make this machine?
Пікірлер: 30