Thanks for such an informative and honest test both thumbs up
@paullorman8924
Жыл бұрын
Thanks for that - I was going to buy one. I'll save the money for something else.
@listairgin
11 ай бұрын
Thanks so very much for sharing this with us all. It’s an over priced low quality item that I will now totally avoid. Your video has saved me a lot of precious time and money. Thank you so much! 🌠🌌🌅👍🏻
@MrNursi
7 ай бұрын
I bought one of these lights and found it a bit rubbish with the timing 'scattering'. Glad it's not just mine
@bernardwarr4187
5 ай бұрын
I had one for many years, and it never really seemed to work very well. Not sure if it’s me or the tool !
@Sternhammer89
Жыл бұрын
During the build of my 1310, I picked up an SP8000 ready for doing the timing. I used it for the first time a few weeks ago and I too found the same issues as you have. For measuring RPM, sometimes it would be steady as a rock, and at other times it would jump all over the place. I found that I had to disconnect it from the car and reconnect it, this would often result in steadying the readings. I used the coil + and coolant take off nut for -ve. I also seem to recall that the plastic clip needs to be as close to the suppressor cap as possible. I am using a 65D dizzy and viper 1.5 Ohm Viper coil. I wonder if the timing light works better with different dizzys? Could you test it using a better cable setup (you mentioned the connector was the same as the Innova?).
@ACDodd
Жыл бұрын
No point in testing it, it should work. If it does not work it’s not really doing what it should
@Sternhammer89
Жыл бұрын
@@ACDodd I wondered if it was the lower quality cables that were the problem, hence maybe swapping them with the Inova?
@ACDodd
Жыл бұрын
@@Sternhammer89 I would have to work out the polarity and check the pin orientation so not going to bother with that. At the end of the day, their are better lights.
@somebloke5565
2 ай бұрын
Mine was unstable, threw out garbage reading as shown here and worse. Would reset to 10 Degs mid-job. Junk Sent back.
@tomthompson7400
Жыл бұрын
still a handy tool to own. Just maybe thats not the one to be buying.
@ACDodd
Жыл бұрын
If you only ever want to set the base timing it works
@CKblue6
Жыл бұрын
I've taken mine to the tip last month. Intermittent strobing that's if it worked at all. Bought a Snap on one and now much happier. Would never buy this item again sorry.
@lemmykilmister450
6 ай бұрын
Don't bother, it's shit really struggles to pick up the HT feed
Пікірлер: 15