Thanks for taking the time to post this. Just a quick comment: instead of eyeballing the center of each screw, it's simpler and more precise to just hook the tape measure over the back screw, and measure to the same edge of the front one.
@BLRTUNING
2 жыл бұрын
Great video on how to troubleshoot this issue.
@jd43jw
Жыл бұрын
Triple checked all my measurements with a machinists ruler. Brass rod gently pushes up against the bottom of the air box but clears the bottom panel. On our other bike it misses the air box but brushes the bottom panel. Otherwise very happy with the performance of the damper.
@saffoto
11 ай бұрын
Thanks for the video this helped me out
@ryker4124
Жыл бұрын
I've watched several install videos and every one has a different outcome as to where the rod travels. When I installed mine I was careful to get all the measurements correct but my rod also hit the plastic. After double checking all measurements to confirm they were spot on I ended up moving the back bracket slightly up. Now the rod doesn't hit the plastic.
@nelsonmedina2016
19 күн бұрын
Question so when you do your oil change, do you have to remove the front bracket that’s on top of the filter to do your oil change?
@broderp
11 ай бұрын
I wish you would have shown the adjustment. It seems that both cap bolts are fixed, but I'm not sure -Hence my previous comment. I also wonder why the end is so long. Couldn't you just cut off several inches of the rod?
@rykermod3521
11 ай бұрын
The system needs the full stroke of the the stabilizer to work properly, if you cut the rod; the rod will travel inside the stabilizer body and and damage the stabilizer.
@mattdavis4759
9 ай бұрын
@@rykermod3521is the steering stabilizer rebuildable?
Пікірлер: 9